SiK Telemetry Radio V3 LED and Connection

100mW & 500mW Version

LED Indicators Status

The radios have 2 status LEDs, one red and one green.
Green LED blinking – searching for another radio
Green LED solid – link is established with another radio
Red LED flashing – transmitting data
Red LED solid – in firmware update mode

Connecting to Pixhawk Standard Flight Controller

Use the 6-pin JST-GH connector that comes with the radio to connect the radio to your flight controller's 鈥淭elem 1 (鈥淭elem 2 can also be used, but the default recommendation is 鈥淭elem1 .

Connecting to a PC or Ground Station

Connecting the radio to your Windows PC or Ground Station is as simple as connecting the micro/type-C USB cable (both included with the radio) to your PC/Ground Station.
The necessary drivers should be installed automatically, and the radio will appear as a new 鈥淯SB Serial Port in the Windows Device Manager under Ports (COM & LPT). The Mission Planner’s COM Port selection drop-down should also contain the same new COM port.

1W version

LED Indicators Status

The radios have four status LEDs, two LED lights indicate the reception and transmission of the USB port. The other two LED lights indicate the status of the RF circuit.
USB-TX LED(Orange) blinking -USB port has data transmission
USB-TX LED off – USB port has no data transmission
USB-RX LED(Orange) blinking -USB port has data reception
USB-RX LED off – USB port has no data reception
Radio LED (Green)blinking – searching for another radio
Radio LED solid – link is established with another radio
ACT LED(Red) flashing – transmitting data
ACT LED solid – in firmware update mode