Pixhawk 6X Pro Supported Firmware

July 11, 2025 pixhawk Pixhawk 6X Pro

Pixhawk 6X Pro is shipped with PX4 FMUv6X Firmware, but it is also supported in Ardupilot. It shares the same firmware as Pixhawk 6X.

PX4

Pixhawk 6X Pro is supported on Master/Main or PX4 1.14.3 release and later.PX4 Firmware Target: FMUv6x

Ardupilot

Pixhawk 6X Pro is supported in Ardupilot 4.5.0 stable release and later. Ardupilot Firmware Target: Pixhawk 6X. Ardupilot firmware can be flash via Mission Planner or QGroundControl. It can also be downloaded here: https://firmware.ardupilot.org/

About The Author

pixhawk

Other Posts by This Author

XBP9X Radio Status LEDs

pixhawkJuly 11, 20250 Comments

Status LEDs The radios have 6 status LEDs, there blue, two orange and one green. The meaning of…

XBP9X Radio Specification

pixhawkJuly 11, 20250 Comments

Product Specification FREQUENCY RANGEISM 902 to 928 MHzTRANSMIT POWER (Software Selectable)Up to 30 dBm*CHANNELS10 hopping sequences share 50…

XBP9X Radio Power

pixhawkJuly 11, 20250 Comments

Supply voltage 5V DC from USB or 6-position JST-GH (100mW) 7~35V DC form 4-position JST-GH (500mW or 1000mW)…

XBP9X Radio Point-to-Multipoint Setup with XBee Radio

pixhawkJuly 11, 20250 Comments

Holybro XBP9X Radio Point-to-Multipoint setup: Use the XCTU configuration software to set the CM, HP, ID, MT, BR…

XBP9X Radio Pinout

pixhawkJuly 11, 20250 Comments

Data Port PinSignalVolt1(red)NC—2(black)RX+3.3V3(black)TX+3.3V4(black)CTS+3.3V5(black)RTS+3.3V6(black)GNDGND Power Port PinSignalVolt1(red)BAT+7-35V2(red)BAT+7-35V3(black)BAT-GND4(black)BAT-GND

XBP9X Radio Download

pixhawkJuly 11, 20250 Comments

XCTUDigi XBee SX 900 RF Module4MBXBee-Radio-Case.stp

XBP9X Radio Dimension

pixhawkJuly 11, 20250 Comments

XBP9X Radio Antenna

pixhawkJuly 11, 20250 Comments

SpecificationsQT900LFrequency range902锝?28 MHzBand Width26 MHzPolarizationverticalGain3 dBiInput impedance50惟SWR鈮?.5Maximum power20WConnectorRPSMA (female)Total length19.6 cm (foldable antenna)Weight40g

Leave a Reply Cancel reply