Category: Flight Controller
Kakute F405 Wing Mini
Kakute H7 (v1/v2/Mini)
Kakute H743-Wing
Pix32 v6
Pixhawk 6C
Pixhawk 6X
Pixhawk 6X Pro
Pixhawk Baseboards
The ports and pinout of the Pixhawk Baseboard v2A and v2B are identical. The only difference is the orientation of the header pins.Pixhawk Standard Baseboard V2APixhawk Standard Baseboard V2B Refer to diagram below for location of pin1. All connectors are JST GH 1.25 mm Pitch unless noted otherwise. The Pixhawk Baseboard v1 has been replaced […]
Get the Pixhawk Raspberry Pi CM4 Baseboard by Holybro talking with PX4 – PX4 AutopilotPX4 Autopilot Link-local networking setup between CM4 and FC Local cable To set up a local ethernet connection between CM4 and the flight computer, the two ethernet ports need to be connected using a 8 pin to 4 pin connector.The pinout […]
To install Raspberry Pi CM4 companion compute onto this baseboard.Disconnect the FAN connector.Remove these 4 screws on the back side of the baseboard.Remove the case of the baseboard, install the CM4 and screw on the 4 screws.
This baseboard is compatible with both Pixhawk 5X & 6X, and any flight controller that follow the Pixhawk Autopilot Bus Standard. FMU PWM OUT = AUX OUTI/O PWM OUT = MAIN OUTRefer to this diagram for location of pin1. All connectors are JST GH 1.25 mm Pitch unless noted otherwise. Power1 Port (2.00mm Pitch CLIK-Mate) […]
Pixhawk 6X with the Pixhawk RPi CM4 BaseboardThe Holybro Pixhawk RPi CM4 Baseboard combine the Pixhawk FC module with the Raspberry Pi CM4 companion computer in on compact form factor with all the connections you need for development. It follows the Pixhawk Connector and Autopilot Bus Standard, allow easy swap of FC Module with any […]
To ensure stable power supply, the RPi CM4 & Flight controller must be powered separately. Flight controller is powered via the CLIK-Mate cable to POWER1 or POWER2 port, and RPi CM4 is powered by the USB C (CM4 Slave) connection.
Categories
Pixhawk 6X Pro Dimensions
Dimension in millimetersPixhawk BaseboardPixhawk Mini Baseboard
AAThe newest batch of Pixhawk baseboard V2 now supports switchable PWM signal voltage (3.3V or 5V). The modification requires the user to open the casing of the Pixhawk flight controller and be familiar with soldering. Any damages caused during the modification are not covered by warranty For V2A RC12 & V2B RC02 To switch the […]