X650 Development Kit NeoPixel WS2812 LED Setup Instruction

PX4 NeoPixel Setup Guide

Note: This is experimental at the moment. Please operate with caution.
The official release of PX4 firmware does not support NeoPixel at the moment. However, you could flash the custom firmware (based on v1.15beta1) below and set up NeoPixel at the Actuator tab in QGroundControl.

2MB
px4_fmu-v6x_x650-rev2.px4

Make sure your NeoPixel LEDs are connected to the AUX PWM outputs. MAIN PWM outputs do not support NeoPixel.

Ardupilot NeoPixel Setup Guide

Follow the instruction below to set this up.
Set NTF_LED_TYPES to include NeoPixel

Setup LED Parameter

NTF_LED_BRIGHT: 3
NTF_LED_LEN : 4
NTF_LED_OVERRIDE: 0

In this example, we connected the wiring as follow:
Motor 1 LED -> AUX (FMU) PWM 1
Motor 2 LED -> AUX (FMU) PWM 2
Motor 3 LED -> AUX (FMU) PWM 3
Motor 4 LED -> AUX (FMU) PWM 4

In the Servo Output Page, set:
#9 function -> NeoPixel1
#10 function -> NeoPixel2
#11 function -> NeoPixel3
#12 function -> NeoPixel4