Category: Docs
Welcome to Pixhawk.Store Official Documentation.
This documentation will help you understand Pixhawk.store’s official product introduction, technical specifications, pinout, tutorials, assembly, etc.
If you have any comments or suggestions on our documentation, please contact us
Flight Controller
GPS & RTK System
Peripherals
Power Module & PDB
Radio
Categories
Remote ID Overview & Spec
AAHolybro RemoteID Module is low cost, small size, and light weight module that broadcast information about UAVs in flight through WIFI & Bluetooth. It supports both CAN and serial protocols. It is a FCC & CE approved radio module.The products run open-source firmware (ArduRemoteID) and provides a so-called standard Remote ID solution, primarily target drone […]
Stanard (JST GHR1.25mm 10pin cable):This JST GH 10Pin connector can be use d on Pixhawk Series 10pin鈥淕PS Module or "GPS1" input port.Secondary (JST GHR1.25m m 6pin cable)锛?/strong>This JST GH 6Pin connector can be used on Pixhawk Series 6pin鈥淯ART & I2C鈥漮r " GPS2" input port as secondary GPS.For Pix32/Pixhawk1/2.4.6/2.4.8 (Molex1.25mm 6pin & 4pin &3pin cable):These Molex […]
Categories
Power Module PM07 Quick Start Guide
The PM07 serves the purpose of a Power Module as well as a Power Distribution Board. It supplies regulated 5.2V to the flight controller from the battery and provides current consumption and battery voltage measurements via an analog signal through a 6 Pin JST-GH cable, along with integrated ESC power & signal distribution for up […]
Categories
Remote ID Pinout
455KBDLVR_AS_CAN_Case.stp
Pixhawk 5X/6X uses digital power module (such as PM02D, D stands for digital), if you would like to use it with an Analog Power Module, see below. PX4 If you are have to use analog power module with Pixhawk 5X or 6X. With PX4 & QGC, you can use an ADS1115 board and wire it […]
Categories
Remote ID Setup & Configuration
AAThe RemoteID Module is controlled by the autopilot system. For normal operation, make sure the module is powered on (LED is on) and make sure the module can communicate with the autopilot system.The Holybro RemoteID module can be configured via the CAN bus (DroneCAN) or UART/TELEM (MAVLink). For instance, you can configure the transmission modes, […]
AAThe Holybro DroneCAN Airspeed is an industrial-grade differential pressure measurement module designed for precision airspeed measurement in various UAVs, including planes, VTOLs, and other vehicles. Equipped with DLVR_L10D digital Pressure Sensor and running ArduPilot AP-Periph Firmware, this module ensures accurate and reliable airspeed data across different flight conditions. Features Wide Pressure Range: Supports up to […]
Categories
Microhard Radio Default Setting
AAHolybro Microhard Radio have been configured to Point to Point Operating Mode and 57600 Serial Baud Rate in factory. Using these parameters, the Radio can communicates successfully with the Pixhawk series flight controller. After Firmware Update or resetting the Radio, you can re-config them as following.In Point to Point operating modes, there must be a […]
Mission Planner Configuration Telemetry Radio V3 configuration:Set a different Net ID for each pair of Telemetry Radio V3, as shown belowConnect all telemetry modules to the computer via a USB hub.Open Mission Planner to locate the base, then connect it withthe flight controllers. Select AUTO connecting as shown below. All recognized flight controllers on the […]