Categories
Pixhawk Jetson Baseboard

Pixhawk Baseboards Pixhawk Jetson Baseboard Dimension & Weight

Weight

Outer alloy case weight: 90g
Without Jetson and Flight Controller: 85g
With Jetson, no Heatsink or Flight Controller: 110g
With Jetson and Heatsink, no Flight Controller: 175g
With Jetson, Heatsink, and Pixhawk 6X Flight Controller: 185g
With Jetson, Heatsink, Pixhawk 6X Flight Controller, M.2 SSD, M.2 Wi-Fi Module: 190g

Dimensions

(Unit in millimeters)
Without Jetson and FC Module: 126 x 80 x 22.9mm
With Jetson Orin NX + Heatsink/Fan & FC Module: 126 x 80 x 38.6mm
Alloy case: 130 x 84 x 20mm

Without Jetson Orin & Autopilot

With Jetson Orin, Heatsink+Fan, and Pixhawk 6X

Jstson baseboard alloy case dimension

Leave a Reply

Your email address will not be published. Required fields are marked *

Other Posts

Categories
Pixhawk Jetson Baseboard

Pixhawk Baseboards Pixhawk Jetson Baseboard Overview & Specification

Features Fully compatible with Jetson Orin NX/NanoCombines the power of Pixhawk & Jetson in a small form factorPixhawk Autopilot Bus (PAB) open source specificationJetson & Autopilot are connected via UART, CAN, and Ethernet Switch Jetson Xaviar NX and Jetson Nano are not compatible. This baseboard will function as a Jetson Carrier without the Autopilot Flight […]

Categories
Pixhawk Jetson Baseboard

Pixhawk Baseboards Pixhawk Jetson Baseboard Ports Pinout

I/O PWM OUT = MAIN OUTFMU PWM OUT = AUX OUTPin 1 starts from the flight controllers like diagram below Power 1 (Main), Power 2 Ports (2.00mm Pitch CLIK-Mate)Pin Signal Voltage 1(red) VDD5V_BRICK1/2(in) +5V 2(black) VDD5V_BRICK1/2 (in) +5V 3(black) SCL1/2 +3.3V 4(black) SDA1/2+3.3V 5(black) GND GND 6(black) GND GND Tel1, Tel3 Ports Pin Signal Voltage […]

Categories
Pixhawk Jetson Baseboard

Pixhawk Baseboards Pixhawk Jetson Baseboard Reference Links

PX4 ROS 2 User Guide | PX4 User Guide (main)Holybro Pixhawk Jetson Baseboard | PX4 Guide (main)Companion Computers | PX4 User Guide (main) Ardupilot Companion Computers Dev documentationROS 2 over Ethernet Dev documentationArduPilot Network Interface Copter documentationEthernet and TCP/IP in ArduPilotArduPilot Discourse Helper Scripts Not found

Categories
Pixhawk Jetson Baseboard

Pixhawk Baseboards Pixhawk Jetson Baseboard CAN setup

AACAN2 on the basboard is conneted internally to both FCU and Jetson module. The basics could be implemented from Nvidia user guide:Controller Area Network (CAN) Jetson Linux Developer Guide documentationNvdia Jetson official CAN setup guideHowever, you could follow the below quick commands might make you able to loopback test the CAN connection between Jetson module […]