Categories
H-Flow (DroneCAN)

H-Flow (DroneCAN) Firmware

AAH-Flow runs the PX4 DroneCAN Firmware. It supports firmware updates over the CAN bus and dynamic node allocation.
H-Flow boards ship with 1.15 or later firmware pre-installed, but if you want to build and flash the latest firmware yourself. See PX4 DroneCAN Firmware > Building the Firmware.
Firmware target: holybro_h-flow_default
Bootloader target: holybro_h-flow_canbootloader

Firmware Update

PX4 can upgrade device firmware over DroneCAN. To upgrade the device, all you need to do is copy the firmware binary into the root directory of the flight controller's SD card and reboot.
Upon boot, the flight controller will automatically transfer the firmware onto the device and upgrade it. If successful, the firmware binary will be removed from the root directory and there will be a file named XX.bin in the /ufw directory of the SD card.

Leave a Reply

Your email address will not be published. Required fields are marked *

Other Posts

Categories
H-Flow (DroneCAN)

H-Flow (DroneCAN) Overview

Overview The Holybro H-Flow is a compact optical flow and distance sensor module that combines a PixArt PAA3905E1 optical flow sensor, a Broadcom AFBR-S50LV85D distance sensor, and an InvenSense ICM-42688-P 6-axis IMU. This all-in-one design simplifies installation, while the onboard infrared LED enhances visibility in low-light conditions.The H-Flow features a Pixhawk-standard 4-pin CAN connector, ensuring […]

Categories
H-Flow (DroneCAN)

H-Flow (DroneCAN) Setup Guide

Mounting The recommended mounting orientation is with the connectors on the board pointing toward the back of the vehicle, as shown in the following picture.This corresponds to the default value (0) of the parameter SENS_FLOW_ROT. Change the parameter appropriately if using a different orientation. The sensor can be mounted anywhere on the frame, but you […]