Categories
Other Posts
Categories
Microhard Radio Default Setting
AAHolybro Microhard Radio have been configured to Point to Point Operating Mode and 57600 Serial Baud Rate in factory. Using these parameters, the Radio can communicates successfully with the Pixhawk series flight controller. After Firmware Update or resetting the Radio, you can re-config them as following.In Point to Point operating modes, there must be a […]
Categories
Microhard Radio Dimension
The flow control of the Microhard Telemetry Radio module is turned off by default, and can be turned on or off by the following methods. Enable CTS/RTS 1锛塁onnect a USB cable from the PC USB port to the USB TYPE-C of the module.2 ) Launch a terminal communications program (e.g. HyperTerminal) and configure for 9600 […]
Categories
Microhard Radio Overview
Holybro Microhard Telemetry Radio integrates microhard Pico Series RF module which is capable of delivering high-performance wireless serial communications in robust topologies, such as Point to Point, Point to Multipoint and secure Mesh (Mesh only available on P900).It uses frequency hopping spread spectrum (FHSS) technology, providing reliable wireless asynchronous data transfer between most equipment types […]
Categories
Microhard Radio Pinout
Data Port PinSignalVolt1(red)NC—2(black)RX+3.3V3(black)TX+3.3V4(black)CTS+3.3V5(black)RTS+3.3V6(black)GNDGND Diagnostic Port PinSignalVolt1NC—2(black)RX+3.3V3(black)TX+3.3V4(black)GNDGND Power Port PinSignalVolt1(red)BAT+7-35V2(red)BAT+7-35V3(black)BAT-GND4(black)BAT-GND
Categories
Microhard Radio Default Setting
AAHolybro Microhard Radio have been configured to Point to Point Operating Mode and 57600 Serial Baud Rate in factory. Using these parameters, the Radio can communicates successfully with the Pixhawk series flight controller. After Firmware Update or resetting the Radio, you can re-config them as following.In Point to Point operating modes, there must be a […]
Categories
Microhard Radio Dimension
The flow control of the Microhard Telemetry Radio module is turned off by default, and can be turned on or off by the following methods. Enable CTS/RTS 1锛塁onnect a USB cable from the PC USB port to the USB TYPE-C of the module.2 ) Launch a terminal communications program (e.g. HyperTerminal) and configure for 9600 […]
Categories
Microhard Radio Overview
Holybro Microhard Telemetry Radio integrates microhard Pico Series RF module which is capable of delivering high-performance wireless serial communications in robust topologies, such as Point to Point, Point to Multipoint and secure Mesh (Mesh only available on P900).It uses frequency hopping spread spectrum (FHSS) technology, providing reliable wireless asynchronous data transfer between most equipment types […]
Categories
Microhard Radio Pinout
Data Port PinSignalVolt1(red)NC—2(black)RX+3.3V3(black)TX+3.3V4(black)CTS+3.3V5(black)RTS+3.3V6(black)GNDGND Diagnostic Port PinSignalVolt1NC—2(black)RX+3.3V3(black)TX+3.3V4(black)GNDGND Power Port PinSignalVolt1(red)BAT+7-35V2(red)BAT+7-35V3(black)BAT-GND4(black)BAT-GND