Multiple Point to Point Setup with Sik RadioPoint-to-Multipoint Setup with Microhard Radio
About The Author
pixhawk
Other Posts by This Author
XBP9X Radio Status LEDs
pixhawkJuly 11, 20250 Comments
Status LEDs The radios have 6 status LEDs, there blue, two orange and one green. The meaning of…
XBP9X Radio Specification
pixhawkJuly 11, 20250 Comments
Product Specification FREQUENCY RANGEISM 902 to 928 MHzTRANSMIT POWER (Software Selectable)Up to 30 dBm*CHANNELS10 hopping sequences share 50…
XBP9X Radio Power
pixhawkJuly 11, 20250 Comments
Supply voltage 5V DC from USB or 6-position JST-GH (100mW) 7~35V DC form 4-position JST-GH (500mW or 1000mW)…
XBP9X Radio Point-to-Multipoint Setup with XBee Radio
pixhawkJuly 11, 20250 Comments
Holybro XBP9X Radio Point-to-Multipoint setup: Use the XCTU configuration software to set the CM, HP, ID, MT, BR…
XBP9X Radio Pinout
pixhawkJuly 11, 20250 Comments
Data Port PinSignalVolt1(red)NC—2(black)RX+3.3V3(black)TX+3.3V4(black)CTS+3.3V5(black)RTS+3.3V6(black)GNDGND Power Port PinSignalVolt1(red)BAT+7-35V2(red)BAT+7-35V3(black)BAT-GND4(black)BAT-GND
XBP9X Radio Download
pixhawkJuly 11, 20250 Comments
XCTUDigi XBee SX 900 RF Module4MBXBee-Radio-Case.stp
XBP9X Radio Antenna
pixhawkJuly 11, 20250 Comments
SpecificationsQT900LFrequency range902锝?28 MHzBand Width26 MHzPolarizationverticalGain3 dBiInput impedance50惟SWR鈮?.5Maximum power20WConnectorRPSMA (female)Total length19.6 cm (foldable antenna)Weight40g
Related Posts
H-RTK ZED-F9P Series (RM3100 Compass) DroneCAN FW Upgrade
pixhawkJuly 11, 20250 Comments
For U-blox Firmware Upgrade, please see here. As of September 1, 2024, the Holybro AP-Periph DroneCAN stable firmware…
H-RTK ZED-F9P Series (RM3100 Compass) Galileo OSNMA Support
pixhawkJuly 11, 20250 Comments
AAWith the newest firmware released by u-blox (v1.5x), all u-blox ZED-F9P now support the Galileo OSNMA feature.Firmware version…
H-RTK ZED-F9P Series (RM3100 Compass) GPS Heading/Yaw (aka Moving Baseline)
pixhawkJuly 11, 20250 Comments
PX4 Guide for RTK PX4 FirmwareGPS Heading with Dual u-blox F9P is supported in the both DroneCAN and…
H-RTK ZED-F9P Series (RM3100 Compass) Overview
pixhawkJuly 11, 20250 Comments
The H-RTK ZED-F9P Rover features the u-blox ZED-F9P GNSS receiver, RM3100 Compass, and a tri-colored LED indicator, providing…
H-RTK ZED-F9P Series (RM3100 Compass) Pinout
pixhawkJuly 11, 20250 Comments
UART 10 Pin VersionUART 6 Pin VersionDroneCAN 4 Pin Version UART 10 Pin GPS Port PinSignalVoltage1(red)VCCPower +5V2RX(in)TTL 3.3V3TX(out)TTL…
H-RTK ZED-F9P Series (RM3100 Compass) Portable RTK Base Station Setup
pixhawkJuly 11, 20250 Comments
Introduction This is a portable solution that sends the RTK corrections via a Sik Telemetry Radio link directly…
H-RTK ZED-F9P Series (RM3100 Compass) Setup & Getting Started (Ardupilot)
pixhawkJuly 11, 20250 Comments
Getting started In this section of the manual, we will cover the basic setup of the units. To…
H-RTK ZED-F9P Series (RM3100 Compass) Setup & Getting Started (PX4)
pixhawkJuly 11, 20250 Comments
Getting started In this section of the manual, we will cover the basic setup of the units. To…
Leave a Reply