Categories
Power Module

Power Module Connector & Wire Rating

The XT60 plug and 12AWG wire that are pre-soldered on Holybro Power module are rated for 30A continuous current and 60A instantaneous current (<1 minute). If a higher current is being used, we recommend that the plug type and wire size should be changed accordingly.

Genuine AMASS Connector Rating

Plug Specification
Wire Size
Cont. Current (4 hours, temperature rise < 60 掳C)
Burst Current (1 minute, temperature rise < 60 掳C)
XT60
12 AWG
30A
60A
XT90
10 AWG
45A
90A
XT120
8 AWG
60A
120A
AS150
8AWG
75A
150A
AS300
6AWG
150A
300A

Leave a Reply

Your email address will not be published. Required fields are marked *

Other Posts

Categories
Power Module

Power Module Download

3D CAD Files 1MBpm02d-full_asm.stp2MBpm03d-full_asm.stp2MBpcba-pm06-0702.stp2MBpm07-pcba.stp6MBpm08-full_asm.stp6MBpm08D-full_asm.stp519KBCAN PM08 Case v003.step

Categories
Power Module

Power Module DroneCAN Power Module Setup

CAN Termination Resistor Software Toggle CAN Termination Resistance Software Toggle | Holybro Docs Parameter Setup Ardupilot Connect the Power Module CAN connector to the Flight Controller's CAN1 Port Change the following parameters:CAN_P1_DRIVER=1CAN_SLCAN_CPORT=1BATT_MONITOR=8BATT_OPTIONS=1Unplug the Power and Restart the Flight ControllerOptional: Right-click on MissionPlanner -> User Items -> Check battery temp to display the temperature on the […]

Categories
Power Module

Power Module PM07 Quick Start Guide

The PM07 serves the purpose of a Power Module as well as a Power Distribution Board. It supplies regulated 5.2V to the flight controller from the battery and provides current consumption and battery voltage measurements via an analog signal through a 6 Pin JST-GH cable, along with integrated ESC power & signal distribution for up […]

Categories
Power Module

Power Module Using Analog PM with Pixhawk 5X/6X

Pixhawk 5X/6X uses digital power module (such as PM02D, D stands for digital), if you would like to use it with an Analog Power Module, see below. PX4 If you are have to use analog power module with Pixhawk 5X or 6X. With PX4 & QGC, you can use an ADS1115 board and wire it […]

Categories
Power Module

Power Module Analog Power Module Setup

PX4 QGroundControl Setup Connect the Power Module to a battery and connect the flight controller to your ground station via USB.Open QGroundControl go Vehicle Setup and Power tab and Input the Number of Cells.Ensure the Voltage Divider & Amps per Volt is correct. All Holybro Analog Power Modules except PM08 use the following:Voltage Divider: 18.182Amperes […]